Labels that have been attached to it: Skoda Superb, Ford Mondeo, Malibu XL, I am one of them. In terms of cost performance, Malibu is indeed exaggerated. Is it the original choice of Malibu owners? Isn't it because you like its "intrinsic"?
Unfortunately, the name was too loud. In order to get rid of this reputation, I had modified the appearance before. It finally didn't look so ugly. But after a while, I always felt something was wrong. One time, I turned on the headlights during the day and discovered this hidden ugly guy. . How could I bear this? I immediately found a car repair shop and replaced the headlights. According to my requirements: good-looking, high-grade, non-destructive installation and stable, the master recommended a car light to me.
The following is the replacement process:
Opening the hood and arranging to install lights was very fast.
To install LEDs, you must first remove the previous halogen lamp and open the dust cover of the lamp.
After pressing down the iron wire that fixes the halogen lamp, you can see the halogen bulb. This was taken out by the master.
Press the black place to unplug the original car power supply.
Then I took out a small halogen light bulb. I didn't expect that this light was so small. Even if the heat was a little higher, the stainless steel underneath was a little yellow.
After removing the halogen bulb, you can install the LED bulb. After picking and choosing, I finally chose this one.
Here is a comparison picture between halogen lamp and LED. In fact, I didn’t take a good picture. The light-emitting point and the buckle position of the two are the same.
Now we have to install the LED lights. This one is a little different. We need to remove the card holder and install it on the car first.
Just watch the master pull it out hard, and the card holder clicks out.
Just put this thing into the car first.
The master said that the high-beam halogen lamp only has one interface. The LED has positive and negative. It needs to be connected with an adapter cable. I think he can just plug it in directly.
Connect the adapter cable and plug it directly into the original car power supply. I heard him say there was only one interface, and I thought it was going to break the line.
Connect the power supply, turn on the light and check before installing.
Turn on the low beam headlights.
It's on, continue to install the light, and insert the light body into the holder fixed on the car.
The master emphasized that when fixing, pay attention to the fact that the lamp beads should be vertical to the left and right sides, saying that only in this way can the light be concentrated.
Put the wires, drivers, etc. into the assembly, then cover the dust cover you just removed and install it on one side.
To install the other side, the shelf and battery box here need to be removed first and then installed. Remove the shelf and electrical box here
The high beam turned out to be a halogen lamp.
After using LEDs both far and near, this is what it looks like.
It's very bright. It doesn't have a lens for high beam and is rarely used. Let's take a look first.
After changing the OCD, I became more comfortable. I changed the high beam to LED and I felt much more comfortable overall. I thought it would be better to switch to the commonly used low beam. But after using LED, I started to look at the high beam candle light and the more I looked at it, the more I looked at it, and the more I looked at it, the more I disliked it. It is white and comfortable.
Finally, the replacement is completed. It looks very good during the day, and I believe it will look good at night as well. Why do I like to modify it? Everyone has the love for beauty.